Quote:
Originally Posted by Bryan
The CDI sits on a small flat piece of plastic bolted inside the air box on right side fender just far enough up to clear the filter. The wires come through the upper right front of the air box and cross over above the rear shock and go down to the lower part of the frame going forward. You should see some tabs that are welded to the frame to bend over the wire loom and hold it in place. When you get to the front of the frame/cradle, the coil wires continue around to the right side where the coil bolts on. The rest of the wires go up the cradle to the steering stem, there should be a single yellow wire with a connector on it that the voltage regulator connects to and mounts on the center cradle . The rest of the wires continue up the center frame tube and around the steering stem on the left side into the head light area.
Hope this makes sense.
|
Thanks for your reply, yeah a little hard to imagine but I will read it again when I'm in front of the bike and try and take it step by step. Thank you again for your help with this