View Single Post
  #23  
Old 05-06-2018, 08:45 PM
hadfield4wd hadfield4wd is offline
Senior Member
 
Join Date: Oct 2015
Location: Roanoke, VA
Posts: 852
Default

I’m not eliminating the internal spacer. I know its needed for preload. You notice the shoulder? It goes in the ID of the bearing. Making the ID 17mm for my axle. I’m going to get a bearing that has a 17mm ID. That shoulder on all the spacers pressed into the bearing is a pain.

I’ll make an internal spacer without the shoulders. This will make bearing changes easier.

Its hard getting my point across on a forum. Thanks for the input.
__________________
Matt

1999 GG EC 250 Six Days
1999 Cagiva Gran Canyon
2001 Aprilia Falco
2001 Triumph Speed Triple for my 20 year old
2000 GG XC250 for my 20 year old
2003 Honda Rancher 350 for the wife
Reply With Quote