Just another tip...
Check that your left side panel is not very close to the kickstand in the up position. If it is too close, you can break/chip the plastic as the kickstand hits it under higher spring tension. You can bend the lower mouting tab on the subframe (the one with the rivet nut) to make the side panel miss the kickstand. It is an easy tweak with some vice-grips. Just a little tweak is all it takes. This pulls the bottom of the side panel further outward.
__________________
Matt
Current: 2009 Yamaha FZ1
Previous: 2001 GasGas TXT280, 2001 GasGas XC250, 2004 KTM 200EXC, 2007 GasGas EC250, 2007 Husqvarna SM610, 2008 Husqvarna WB165
|