Ok checked the float assembly and it seemed perfectly straight. Remeasured the float height and came up with 16. Now Im not sure if what I did is right but it worked. The tang for the needle seemed to be barely pushing on the spring loaded pin in the bottom of the needle when the float was pushed into the bottom of the carb so I bent the tang down slightly (toward the needle) and came up with a 17mm float height. Now there is no fuel leaking when the bikes on the stand and will leak fuel when the bike is tilted to about 45 degrees to the side (stand up). Havent had the chance for a test ride yet so will do so tomorrow.
|