Thanks a lot for your help Dave. I have not tried new needles yet. I just got my N3CH and NEDW needles in the mail. I put in the NEDW on 3rd clip. I also just pulled the carb apart to check the float. I do not know where exactly to check it. Here is a video. When I hold it at 90 degrees it seems like the float is in a ?neutral? position with the line parallel to the carb body (even though you can?t see it). Is this the position that the float needs to be set? If so it is way less than 16mm so I need to adjust it.
I read about making sure it?s not pushing the pin down that the tang is against but when I rotate it like in the video it seems like the pin always has pressure except when I tilt the carb past 90 and the float falls out.
To adjust the tang do I have to pull it all apart, bend it, and put it back together or can I adjust the tang with it assembled?
Do you know of any good videos or instructions for dummies? This is literally the first carb I?ve taken apart.
http://www.youtube.com/watch?v=t9qvJZ-zdO8