[stainlesscycle]

bike was fine, now i get no spark.

i'm thinking it's the stator. i hope it's not the cdi.. but my coil gives me a wonky reading..here's what i have:

coil
primary windings (blu/w to g) - .7 ohm (i would assume i should get 2.5ohm- 5 ohm right?????)
secondary windings (no plug wire) 12.7 kohm

stator:
pulser coil 93ohm, jumps to 115ohm when magnet passes (this i assume is good.)
exciter coil - 0ohms and under 2volts when kicked 5 times. (this is not good i assume..)


any ideas????