So it is not possible to not fully secure the pinch bolts on the forks?
2. I was thinking of having a wheel with 26mm. However I will use the 25mm axle that is original in gasgas. This will fit good in the forks. However, to do that, I need to make the spacer 0.5mm wider on each side (1mm in total). Is this possible? I was thinking of buying a spacer that has an inner diameter of 25mm (for my org axle) and then having the outer diameter the same of the inner diameter bearing.
To sum up. Having a wider spacer than usual to have a smaller axle in a wheel that is made for a bigger axle.
|