[CombatYoga]

I finally got the old gal running so it's time to sell her.

Originally purchased from Paul at County Cycle in 2014 where he turned it into one of his woods weapons.
The rectifier went out on me at the Zink Ranch NEPG enduro in the fall of 2016. I bought a 4T when I got home and my GasGas has been sitting since then.
A fellow member on the forum here helped me diagnose the rectifier issue (thanks again!). I never put an hour meter on it, but estimate it has somewhere between 250-300 hours.

The bike definitely has some race hours on her, but runs solid (VPR and 93 octane pump gas mixed 50/50 with Amsoil Dominator at 60:1).

You can find some of my old posts here on the forum - I stripped the estart off the bike, so it is kick only, but that saved somewhere north of 7 lbs. if I remember correctly.

I have one of the last batches of Richard's awesome House of Horsepower setup (pipe, silencer, and carb slide). This bike definitely rips.

There's so much aftermarket stuff on this bike it's crazy - I'm not even sure if I remembered it all!

- Fresh top end
- Suspension has been resprung and revalved by Doc at 812 Suspension for a 205 lb. B rider.
- House of Horsepower cone pipe & Enduro Engineering carbon fiber pipe guard
- House of Horsepower shorty silencer with anodized end cap
- House of Horsepower custom throttle slide
- Rekluse EXP 2.0 clutch with Honda CRF 450 clutch plates
- Scott Steering Stabilizer
- Twisted Engineering Carbon Fiber handlebars and integrated handguards
- S3 High Compression head (other 2 inserts included)
- G2 Quick turn throttle
- Motion Pro throttle cable
- BRP Radiator guards
- BRP Chain guide
- TM Designworks skid plate
- Core Moto custom rear brake line
- Extended rear brake master cylinder radiator
- Checkpoint high volume aluminum impeller
- Checkpoint Racing power valve cover
- JD Jetting kit installed
- Motoseat custom seat cover
- Motocal custom graphics
- FunnelWeb Air filters (including extras)
- Bulletproof Designs shark fin rear disc protector
- Raptor titanium footpegs
- Yamaha kick lever
- various other anodized bits and pieces

Asking $2700. I race some national events along with some friends so there is a possibility I could arrange delivery depending on location/date.