A few pics showing the progress - I'm in no real rush to get this done. Have a few weeks up my sleeve so will just be plodding along while also spending some time with the family.
Engine removed from frame. The frame will get a good clean up at the same time.
The pipe has been covered in a P3 carbon guard since new. Its been neglected. I don't clean it with a toothbrush or anything, and only if I remember do I give it a spray in innox. Shes got surface rust everywhere but no structuaral damage. Theres some cosmetic damage to the P3 too. A few scrapes. It works well enough.
Put in a bit of time with a wire wheel on the angle grinder, drill, and dremel. Not too bothered about the final result as it'll only end up looking used again in no time. Scrubs up ok. P3 still needs a wash.
