Try loosening both clamps and see if you can rotate whole axle 1/2 turn so the puller arm is away from fork.use both puller arm and hex cap to rotate forward(you could slip a ring spanner over puller arm for leverage)this should free any binding between hexcap/clamps.then clamp the puller arm end and try loosening hexcap nut again.leave the puller arm pointing forward/down.once the hexcap is loose a few turns,loosen puller end also and rubber mallet the hex cap.remove cap,pull axle.when you reinstall leave a little clearance between puller arm and fork (makes it easier to get a ring spanner on)
__________________
2013 ec200r
|