Is the pilot jet drilled straight through and cross drilled?
The slid that you put a screwdriver into to remove and install the jet has a hole right in the center of the jet, on the other end there is a corresponding hole but I cannot see light straight through.
I know this is no comparrison but my boys pw50 had a clogged pilot jet and you could see straight though that one.
This leads me to believe that it may be clogged.
I have it soaking in carb cleaner right now and I will be blowing it out tonight when I get home to see if it opens up. Im hoping this was my issue.
The bike did start much easier before. I am also going to clean the plug and try again. I will also buy new ones in case that doesnt work.
Any more tips are greatly appreciated.
|