All fixed
The symptom, was after the bike warmed up the electric start button would not work, as in you pressed it and nothing happened, as if the switch contacts were not connecting.
The problem ended up being the three wire connection under the tank. It rests flat on the rectangular oil reservoir section of the frame. Basically the little bullet terminal was not pushed in far enough for the small one way barb to hold it properly in the plastic housing. The bullet connector must have just made contact when cold, but when the plastic got hot from contacting the frame(hot oil reservoir) expansion must have broken connection
Have since pushed the bullet connector firmly in the plastic housing and the problem is now gone
Thanks for all the feedback
Cheers
gasser-downunder
|