|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
AS1 float bowl question
I am adjusting the float level on my 2010 EC300 and have a question. Should fuel leak when the floats are pushed all the way to the top? If not how can I stop the flow? It dribbles fuel whenever the petcock is on. Any help would be appreciated.
Trailrider |
#2
|
|||
|
|||
Take the assembly apart, clean out the fuel inlet where the needle sits with carb cleaner and a small cotton bud. Fit a new needle and adjust float height.
__________________
2006 EC300 Enduro - Ignitech CDI - 38/NECW#2/165 FMF gnarly, FMF shorty, .50 front 5.7 rear 2016 RM-Z450 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Carb float bowl screws? | Niall-griffiths | Enduro Intake/Carburetion - 2 stroke | 5 | 03-06-2014 07:52 PM |
float bowl hight | bonkeye | Enduro Intake/Carburetion - 2 stroke | 2 | 04-26-2012 03:01 AM |
Carb issues - Float bowl? | Hicksi | Enduro Intake/Carburetion - 2 stroke | 7 | 10-19-2011 11:21 AM |
float bowl height on 2010 300??? | nambo-trev | Enduro Intake/Carburetion - 2 stroke | 4 | 06-19-2011 01:08 PM |
Float Bowl HELP! | gasIdaho | Enduro Engine - 2 stroke | 3 | 07-18-2007 09:30 PM |