|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Piston exhaust port bdc pic
Howdy,
After my tuner did the porting and head work i never bothered to look at piston height at bdc. It might actually go a hair lower than the pic, but would this be considered as good as flush or is there more top end to be had. Two green gaskets used, i assume gasgas oem ones, .3mm each.... uploadfromtaptalk1442164212333.jpg Sent from my SM-N910F using Tapatalk
__________________
2001 EC300, mild porting and head work, DEP silencer, EC200 CDI |
#2
|
|||
|
|||
Mine is just a little lower than that. I am running a single .5mm oem gasgas gasket.
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar |
#3
|
||||
|
||||
I could have taken you a photo if you posted yesterday. Had my pipe off for vibey O-rings.
I run a single 0.5mm and have some piston above the port. Not as much as in your pic though. The dyno simms that TSP ran for me back when I first modified my 2010 model showed a much more usable power curve this way rather than gaining a little at peak RPM and giving up a whole lot in the mid range. |
#4
|
|||
|
|||
I just did my topend and this is the build thread. See the photo on post 7 on this thread.
http://www.gasgasrider.org/forum/showthread.php?t=19892
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Port Timing | farmerj | Enduro Engine - 2 stroke | 8 | 08-15-2012 06:44 PM |
exhaust port timing | stainlesscycle | Enduro Engine - 2 stroke | 0 | 10-17-2011 01:26 PM |
ec 300 sub port | Gasgasogeros | Enduro Engine - 2 stroke | 13 | 10-24-2010 03:04 PM |
Minor leak from exhaust port help? | jetfish | Enduro Intake/Carburetion - 2 stroke | 5 | 12-24-2009 06:10 AM |
FYI, check BDC piston/lower port clearance. | socalscott | Enduro Engine - 2 stroke | 3 | 11-26-2008 01:43 PM |