![]() |
|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
![]() |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
![]()
I'd like to drain my fuel from the float bowl after each ride but I'm not sure if there is a trick or what? Seems too tight for a wrench to get to it.
![]() 2002 xc300 btw |
#2
|
||||
|
||||
![]()
turn the petcock to "off" and just tip the bike all the way over, almost to the ground. this will remove liquid gasoline, but it can still varnish, the only other way ive heard is to take the carb off.
__________________
Le Crutan ![]() 98 ec250 sixdays, doma, eline pipe guard, zokes shivers from a cr250,fredette racing chain slider, protaper withbarkbusters (SOLD) ![]() ![]() Last edited by mountain thumper; 08-27-2009 at 07:10 PM. Reason: +info |
#3
|
|||
|
|||
![]()
Or turn the petcock to off and keep the motor running until it stops.
|
#4
|
||||
|
||||
![]()
do you not worry about leaning the bike out by doing that? I mean, starve it of fuel and oil?
|
#5
|
||||
|
||||
![]()
Nah, not at idle, hardly needs any oil.
|
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
New Bikes!!! | JRH250XC | SouthEast United States | 2 | 10-09-2010 11:17 AM |
09 Bikes | hasslbri | General Discussions & Announcements | 9 | 02-12-2009 06:28 PM |
08 ISDE bikes | SpeedyManiac | General Discussions & Announcements | 9 | 07-02-2008 04:12 PM |
Used bikes vs. New | Riding4fun | General Discussions & Announcements | 10 | 10-14-2007 04:54 PM |
So what "trick" aftermarket bit have you got on your EC300 | spd33y | General Discussions & Announcements | 3 | 11-03-2006 02:52 PM |