|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Best reed cage for 2001EC 300
I think I have decided to keep my 2001. I am pretty sure the boyseen is in there now. I would like to have a little more top end since it pulls just fine on the bottom. Will the Vforce III make much difference?
|
#2
|
||||
|
||||
My '03 250 picked up some everywhere, but mainly low to mid going from the RAD valve to the VForce II. The 300 and the VF III may be a different story, hard to say. You could also experiment with cyl deck height/compression with base gaskets, timing, and removal of the reed spacer.
|
#3
|
|||
|
|||
My '03 had a Rad Valve that came with Power Reeds (dual stage - fiberglass/fiberglass). I installed Pro Series reeds (dual stage - carbon fiber/fiberglass) and got better performance on bottom and particularly on top. The reeds are from a '96 YZ250, part number PSR 21).
__________________
'15 YAMAHA WR250F, '75 YAMAHA TY80 Gone: '00 380 EXC, '03 EC300, '07 YZ250, '07 250 XC-W, '08 YZ450F, '12 CRF250R |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
V force 2 reed cage | Bailey28 | Enduro Engine - 2 stroke | 16 | 05-18-2011 08:00 PM |
Vfrorce reed cage install | blanc | General Discussions & Announcements | 0 | 04-11-2011 04:55 AM |
Reed cage removal | skid jackson | Enduro Engine - 2 stroke | 6 | 03-26-2008 10:26 PM |
Twin Air aluminum filter cage..... | gasgasman | Enduro Product Announcements | 31 | 12-12-2007 08:04 PM |