|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
Slider question
I have a Gas gas Wild 300 two stroke. I just bought the bike and the bottom end need some cleaning up and it loads up. I'm at 5200 feet. The carb is jetted
Main 150 pilot 40 ...1/2 a turn out needle in the top position n1ef is the needle number slide is a #6 I have a #9 slide. What does the slide numbers mean and whats the difference between a #6 and a #9? Does anybody have a start point on what I should start with? It also came with another needle #CHN
__________________
2004 Gas Gas Wild 300 ITP beads all around |
#2
|
||||
|
||||
Check the jetting thread with the chart. You motor is the same as the EC300 so look for similar situations. Jetting is alway talked about on here.
|
#3
|
|||
|
|||
Go to the bottom of this article for throttle slide (cutaway).
http://www.superhunky.com/feb01rsVintageMikuniTech.html Here's a direct link to the current jetting database. http://www.gasgasrider.org/gallery/d..._22feb2008.jpg |
#4
|
|||
|
|||
You're running a 150 MJ. WHOA!!!!
|
#5
|
||||
|
||||
__________________
2004 Gas Gas Wild 300 ITP beads all around |
#6
|
||||
|
||||
A 150 MJ would cook both my EC300s in minutes at 5200. I run a 165 to 168 at a 6000 ft ASL base in Idaho.
|
#7
|
||||
|
||||
There is also a very big difference between a #6 and #9 slide, with #9 being a lot leaner (#6,#7,#8, #9, rich to lean). I could be wrong, but I would think that with the Quad being a lot more load on the motor than the bike, you would want to be richer for the same conditions if anything.
Check the float height before any jetting sessions. |
#8
|
||||
|
||||
Thanks for the info guys,
__________________
2004 Gas Gas Wild 300 ITP beads all around |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Chain slider question. Please help | joey11 | Enduro Chassis & Body | 3 | 12-05-2008 06:43 AM |
chain slider / chain guide crossover? | bondo | General Discussions & Announcements | 1 | 09-01-2008 09:13 PM |