|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Rear Axle
Some advice please, I have removed the bearings from the rear wheel because the wheel had some play in it. I cleaned the axle with a wire brush to remove some dirt and rush/old grease and found wear makes where the bearing are located on the axle, it's like a very small grove worn into the axle the width of the bearings. Btw the old bearing where fine however these will be replaced.
Question do I need a new axle? Thank in advance EC 250 2008 |
#2
|
||||
|
||||
Quote:
|
#3
|
|||
|
|||
Thanks for the advice
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rear Wheel Axle | singletracker | Enduro Chassis & Body | 38 | 07-24-2013 09:08 PM |
rear axle Q | nokturnal | Enduro Chassis & Body | 4 | 06-13-2012 10:52 PM |
txt 250 1999 rear axle | Rabbitist | General Discussions & Announcements | 0 | 03-15-2012 03:27 PM |
Extended Rear Axle -450 Wild HP | Beardy | Other GasGas Bikes/Quads | 3 | 07-01-2009 07:43 PM |
rear axle nut | skid jackson | Enduro Chassis & Body | 2 | 06-17-2007 06:52 PM |