|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
2000 Xc 250 wont start In mesa arizona
Ok here we go,
My bike will not start, here is the run down of what Ive done and any help you have to offer would be needed. 1 kick it over for a million times 2 drain all gas and put fresh pre mix in it 3 changed plugs 4 held new plug outside against head to look for spark,( no spark ) Backround A week ago road it for 20 mins on this little trail close to my house Was puting on the trailer and a strap broke bike fell over on the right side. I went to go riding this week no start. The kickstarter feels a little different but that could be me, looked for loose wires dont see any. Could the coil have gone bad, could the kill switch be acting up, has a stator ever been knocked loose, where to start any help.(Oh ya going to gordens well in 2 weeks gotta have the gas gas) Thanks Justin Last edited by justinmanus; 10-27-2006 at 10:39 AM. Reason: typo's |
#2
|
||||
|
||||
First disconnect the kill switch and try it.
Next go through all your electrical connections, starting at the coil being it fell on that side (could it have hit the coil??). I crashed hard enough this summer to break the brake fluid resevoir off the frame with my knee brace, so a damged coil/wire is possible. Check the HV wire connection to the coil and plug cap. There is a screw that just threads into the wire on each end. Sometimes this comes loose. You can cut a few mm off each side and thread the wire into the coil and the cap back on the wire. Use a little silicone RTV to seal it. |
#3
|
|||
|
|||
2000 Xc 250 wont start In mesa arizona
It may have hit the coil not sure no visable damage, I will check all the wires leading into the coil again just to confirm when i get off work.
Thanks justin |
#4
|
|||
|
|||
"2000 Xc 250 wont start In mesa arizona"
Will it start in Tempe ? (lol. sorry.) |
#5
|
|||
|
|||
Hey I live in Mesa too, I haven't see you out on any of the trails though. I'm on a yellow EC200, do lots of riding at Sycamore.
As for no spark with the plug, did you do this in a a lit area? Sometimes it can be really tough to see the spark if you're not in the dark. That's all I've got. |
#6
|
|||
|
|||
Have you tried starting it in any other states ?
Sorry, I couldn't resist |
#7
|
|||
|
|||
yes ive tried it in all the closed city's and it still wont start. I bought a new coil today but will not be here for a couple days.
I ride sycamore sometimes and P&D in scottsdale Thanks for all the support next I will try a different state if that dont work Justin |
#8
|
|||
|
|||
As GMP said, Don't overlook kill switch. Take it off the bars and try......been there.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2005 FSE450 wont start | itsagas | Enduro Engine 4 stroke (including EFI & Exhaust) | 5 | 05-16-2010 08:38 AM |
EC200 kick start lever (2000 model) | sireid | Enduro Chassis & Body | 11 | 01-24-2010 02:56 AM |
02 EC 300 wont start | GENO 300 | Enduro Engine - 2 stroke | 0 | 09-21-2009 10:02 PM |
EC200 wont start | Skele | Enduro Engine - 2 stroke | 25 | 09-06-2009 10:34 AM |
wont start | clerky clerk | Enduro Engine - 2 stroke | 8 | 11-01-2008 01:18 PM |