|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Big End Rebuild - crank seals
I am busy trying to arrange to do a big-end rebuild on my 2010 EC300.
the GG supplier near me has informed me that they have both crank bearings and the conrod, however the crank seals are not available and according to them are only available from GG. Anyone know if there is a cross-over seal from a different brand or if they are in fact available from a bearing shop?
__________________
2003 txt250 Pro 2013 Ossa 280i |
#2
|
||||
|
||||
|
#3
|
||||
|
||||
I picked up a stator side main from the local bearing shop, and will have the pinion side here in my spares too. All should be easily found locally.
|
#4
|
|||
|
|||
Thanks. This is for the seals, not the bearings?
__________________
2003 txt250 Pro 2013 Ossa 280i |
#5
|
|||
|
|||
also any special tools required, still trying to decide if i do it myself or send it to my mechanic, either way i need all the parts upfront as the mechanic is not a GG mech.
__________________
2003 txt250 Pro 2013 Ossa 280i |
#6
|
||||
|
||||
I believe these are correct for the older GG bikes. I think they will work on the new ones too.
Left hand side CRANK SEAL KOK 20x35x6 ? VITON, KTM 47030076100 2004-2014 105 85 65 Right hand side CRANK SEAL KOK 38x52x7 - VITON, KTM 0760385273 1994-2014 250 300 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
GG FSE 450 crank shaft and other parts [rebuild] | V1T0 | Enduro Engine 4 stroke (including EFI & Exhaust) | 8 | 10-27-2018 11:43 PM |
99 ec 200 crank rebuild | sweeper | Enduro Engine - 2 stroke | 5 | 03-09-2014 11:59 PM |
06 300 o-rings on crank? rebuild advice | hillbilly | Enduro Engine - 2 stroke | 1 | 03-19-2012 05:32 PM |
Crank rebuild? | jayc | Enduro Engine - 2 stroke | 9 | 03-30-2011 02:36 PM |
Crank seal gone on rebuild? | stay_upright | Enduro Engine - 2 stroke | 11 | 09-13-2009 03:49 AM |