|
Enduro Product Reviews Feedback & Comments on Products Tested |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Ricochet Skid Plate
Just mounted one of these skid plates. Very easy to install. Mounting brackets are steel. The whole rig is very stout and priced right. I had a CRD plate and it broke after 1yr and very few rock gardens. Junk
Check'em out if you are looking for a plate sans the combo pipe protector. http://www.utahsportcycle.com/store/page20.html 05' EC300 |
#2
|
|||
|
|||
I've bought two, one for the DR-Z and one for the YZ. Both are quite sturdy, mounted easily and fit up well.
__________________
'15 YAMAHA WR250F, '75 YAMAHA TY80 Gone: '00 380 EXC, '03 EC300, '07 YZ250, '07 250 XC-W, '08 YZ450F, '12 CRF250R |
#3
|
||||
|
||||
How much do they cost?
How is the fit, including access to the both the drain bolts?
__________________
2004 GasGas DE250 |
#4
|
|||
|
|||
I'll have to double check but I think it was $65 and $4 for shipping. I live pretty close but they didn't over charge me for shipping. The fit is really good IMO. The clutch drain hole lines up perfect. Not sure what other drain hole you are referring to. Has two front brackets and one rear(but mounts to the side)...semi circular that wrap on to the frame tubes. I put some taped foam onto the frame tubes for a snug, vibration free fit
|
#5
|
||||
|
||||
Thanks.
I was referring to the crankcase drain. Already pulled mine trail side once.
__________________
2004 GasGas DE250 |
#6
|
|||
|
|||
Thanks for the report. Any chance for installed pics?
__________________
Aaron '05 EC300, '85 CJ-7, '03 FJ-100, '06 STI |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
EC Skid Plate | cdn280 | Enduro Product Reviews | 32 | 10-15-2010 04:22 PM |
06 300 skid plate on a 10 | Diddel | General Discussions & Announcements | 1 | 06-09-2010 04:28 AM |
Skid Plate | Tom Zelko | Enduro Chassis & Body | 30 | 03-04-2008 06:44 AM |
Hyde skid plate | killergasser | Enduro Product Announcements | 40 | 06-07-2007 08:20 PM |
Ricochet Skid Plate | gasIdaho | Enduro Chassis & Body | 0 | 01-03-2007 12:07 PM |