|
|
|||||||
| Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
|
Thread Tools | Display Modes |
|
#1
05-31-2013, 10:38 PM
|
||||
|
||||
seating the bead
So I just changed out the MX tire on my new bike to my favorite MT-43 trials tire and am having the same problem I always do. The bead does not seat right away.
I get the new tire installed and inflated to up to 60 lbs, but the bead does not seat itself. If I ride the bike off road for a little bit the bead will usually set, but I was just wondering if there is an easier way to do this? my 12v compressor is for sure slow, do I need a real 120v compressor to shock it into submission? 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Anyone use a bead buddy?? | nambo-trev | General Discussions & Announcements | 12 | 05-21-2013 08:04 PM |
| did u rim bead lock question | jhendr3702 | Enduro Chassis & Body | 2 | 03-08-2010 09:12 AM |
Threaded Mode