|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
01-16-2008, 03:51 PM
|
|||
|
|||
tight nut
Isplit the cases ,changing crank bearings.My question is ifanyone has a trick to breaking that inner 30mm nut ,not the one on the c/basket,the one on the crank itself.My air gun at 130 psi won,t buch it.Keep in mind this is the first time in this motor.EC300 06 HELP!!!!!!!!!!!
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tight muddy corners - sliding the back | stay_upright | Riding Techniques & Training | 34 | 04-25-2012 07:00 PM |
| Kick starter is tight | jyellard | Enduro Engine - 2 stroke | 3 | 10-11-2009 12:31 AM |
| Acerbis Profile X-Tight Boots | Niloz | Enduro Product Reviews | 6 | 01-16-2009 09:41 AM |
| Seeking EC 300 setup suggestions for tight trails | Gregarious | General Discussions & Announcements | 11 | 02-07-2008 10:35 PM |
| DE300 Suspension in tight woods | GregM | Enduro Suspension | 3 | 07-29-2006 09:46 AM |
Threaded Mode