|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Ec300 clutch assembly position
I needed to replace my kick start shaft so I disassembled my clutch to do so. Then I read this in the shop manual:
Note: The clutch hub has an assembly position with respect to the primary shaft. Mark the position using a permanent marker on the grease ring. So how important is this? Since I didn't mark it is there any way to determine the assembly position? Is it because its balanced or something? Thanks, -Josh |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Is clutch basket position critical on re-assembly | hillbilly | Enduro Engine - 2 stroke | 1 | 04-06-2012 07:32 AM |
2008 EC300 clutch assembly position | mwoody98 | Enduro Engine - 2 stroke | 0 | 03-13-2012 09:52 PM |
Looking for a clutch master cylinder assembly... | SpeedyManiac | General Discussions & Announcements | 5 | 05-09-2008 07:06 PM |