|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Checkpoint PV Cover and other newbie ???
More ignorant newbie ???
I have two new to me GasGas 250s (well three ) but only two of them have these Checkpoint Covers on them. Any reports on their effectiveness? I tried searching here and also Googled and didn't come up with much. They appear to be just covers that can be easily switched? But before I go yanking it off to switch to a different bike... is there other internal stuff associated with the cover? I assume I'll at the least need a new gasket... The PO has managed to strip out the allen heads on ALL SIX of the oil plugs They're functioning o.k. since driving an appropriately sized Torx bit in there to "cut" a new socket, but I'm wondering... are those plugs notoriously soft or was the PO just careless. IS there a better alternative than the stock plugs? These bikes also all have FMF Fatty pipes with Turbine Core Silencers. Where does the Turbine Core fit on the Quiet scale? I'd like these things as quiet as possible. Last one for now. I can imagine weasling some tools into the Fatty pipe to try and bang out a few dents, but is there an "accepted" or efficient way to approach this. The pipe on one of the bikes is pretty hammered...
__________________
Ross '05 MC 250 '91 Husky 610wxe '04 Duc M800 R.I.P '06 Duc S2r 1000 R.I.P '07 Duc S2r 1000 still rubber side down... ---------------------------------------------------------- May be so... May be not so... My Website |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
steering damper with checkpoint triple tree | stainlesscycle | Enduro Chassis & Body | 8 | 09-11-2009 11:46 AM |
newbie needs some help!!! | sandking11 | Enduro Suspension | 4 | 01-14-2009 07:36 AM |
Newbie here | c-152 | General Discussions & Announcements | 2 | 04-03-2008 08:59 AM |
Help a Newbie Out! | chambersc | General Discussions & Announcements | 7 | 10-22-2007 03:21 PM |