|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Ec250 pv not opening
Hello from Ireland,my bike is a 07 ec250.Basically it has no top end as the pv is only opening half way at wot.I adjusted the pv as per sticky on this forum and even stripped governer to check for missing balls but all was ok.As the sticky is mostly about not fully closing,poor low end and rattly running i was wondering has anyone any ideas on how to get my pv to fully open.If I jam pv fully open it has no bottom end but screaming top end so its only pv mechanism thats stopping it rev out fully.Any suggestions are warmly welcomed,Cheers Gene.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OHSCS Opening race | rbm33 | Pictures & Videos | 2 | 03-05-2013 07:49 AM |
difference between ec250 and ec250 race? | Dirt Addict | General Discussions & Announcements | 2 | 10-24-2009 02:56 PM |