|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Piston exhaust port bdc pic
Howdy,
After my tuner did the porting and head work i never bothered to look at piston height at bdc. It might actually go a hair lower than the pic, but would this be considered as good as flush or is there more top end to be had. Two green gaskets used, i assume gasgas oem ones, .3mm each.... uploadfromtaptalk1442164212333.jpg Sent from my SM-N910F using Tapatalk
__________________
2001 EC300, mild porting and head work, DEP silencer, EC200 CDI |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Port Timing | farmerj | Enduro Engine - 2 stroke | 8 | 08-15-2012 06:44 PM |
exhaust port timing | stainlesscycle | Enduro Engine - 2 stroke | 0 | 10-17-2011 01:26 PM |
ec 300 sub port | Gasgasogeros | Enduro Engine - 2 stroke | 13 | 10-24-2010 03:04 PM |
Minor leak from exhaust port help? | jetfish | Enduro Intake/Carburetion - 2 stroke | 5 | 12-24-2009 06:10 AM |
FYI, check BDC piston/lower port clearance. | socalscott | Enduro Engine - 2 stroke | 3 | 11-26-2008 01:43 PM |