|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2t Exhaust Dent Removal
Have any of you made a bracket to block the ends of the expansion chamber to allow it to be pressurized for dent removal?
I have found these http://www.24mx.com/pipe-repair-kit but as i am intending to remove the dents using water pressure i am not sure if these will seal properly. Any of you made any other tools for this - and any of you using water pressure? see the video link below: https://www.youtube.com/watch?v=LTPhjaKfQRA
__________________
2003 txt250 Pro 2013 Ossa 280i |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
black exhaust cat removal pic | mattlloyd50 | Enduro Engine - 2 stroke | 16 | 04-16-2019 10:58 AM |
Pipe dent | GasTimppa | Pictures & Videos | 6 | 11-06-2012 04:10 PM |
exhaust pipe removal | BryanMcc | Enduro Engine - 2 stroke | 7 | 06-15-2012 08:56 AM |
Pipe Dent Removal | savage sausage | United Kingdom | 22 | 02-21-2012 07:51 PM |
Dent Removal | PEB | Enduro Engine - 2 stroke | 7 | 12-27-2007 09:23 PM |