|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Remove the two bolts holding on the shaft block and remove the assembly:
Lift out the centrifugal mechanism: Lift the kick start return spring out of the hole and release the tension: Remove the starter pinion circlip: Lift out the inner starter pinion and spacer washer: Lift out the Starter pinion assembly: Remove the gear selector spring: Lift the gear selector unit straight out of the case. Mine didn't come out too easily. It got tighter the further out i pulled it. There is a small white plastic bushing under it. Don't forget to grab it. Remove the spring from the hole and remove the bolt that holds in the gear lock: Last edited by RockefellerGG; 05-14-2016 at 07:01 PM. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Complete 2002 ec300 rebuild/conversion | astout93v | General Discussions & Announcements | 1 | 12-07-2014 12:58 PM |
S3 Race Custom Modified EC250 Complete Rebuild | Jakobi | Enduro Engine - 2 stroke | 173 | 06-23-2014 03:12 AM |
2011 ec250 engine complete 70hrs | roverhybrids | Parts | 3 | 01-16-2014 08:20 PM |