|
|
|||||||
| General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
|
Thread Tools | Display Modes |
|
#1
07-13-2016, 12:54 PM
|
|||
|
|||
Advice for buying a 2011 EC300
I am new to this forum and I'm sure glad I found it. A wealth of info here for sure.
I have raced and rode bikes for over 25 years. I am looking for something that is wood specific and always wanted to try the GasGas. I am looking at a 2011 EC300 and was wondering what I should look for when checking out the bike, Other than the normal bearings, sprockets etc... Also I noticed , while searching the interweb for a nice Gas Gas, that anything over a 2011 are like hens teeth. Why so few out there compared to the 2011 and under? here is the bike I am going to look at this weekend and hopefully bring back to my garage. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Advice on new ring work required for EC200 2011 six days | mwinschel | Enduro Engine - 2 stroke | 5 | 10-17-2015 04:56 PM |
| buying goldwing any advice | Stoby | All Other Bikes... | 10 | 05-26-2014 09:03 PM |
| Advice sought - used Nambotin purchase (EC300) | Timfish42 | General Discussions & Announcements | 5 | 05-24-2014 03:34 PM |
| 2011 EC250 graphics fit 2011 EC300? | Jarvo_325 | Enduro Chassis & Body | 2 | 11-25-2012 06:28 PM |
| 2011 300 SixDays Set Up Advice | AZRickD | Enduro Suspension | 23 | 12-29-2010 09:17 PM |
Threaded Mode