|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
08-11-2016, 02:14 PM
|
||||
|
||||
output shaft oil seal size
can anyone confirm the correct size of oil seal for the countershaft?
I bought a 30mm x 40mm x 7mm as this is what the GG manual said and it's leaking oil. Ive only just finished the complete engine rebuild, and lets say it was a bit of a pisser watching the oil drip out of the new seal. I take it i can just lay the bike over and put in a new one, or is it a case of draining the oil and starting again. thanks 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Leaking Counter Shaft Seal | fasteddy | Enduro Engine - 2 stroke | 8 | 08-09-2016 03:23 PM |
| Ec250 Output Shaft seal | Scotty97 | Enduro Engine - 2 stroke | 9 | 01-15-2016 07:59 PM |
| Inner and outer counter shaft seal | skid jackson | Enduro Engine - 2 stroke | 10 | 11-18-2010 09:59 PM |
| help and advice please 400 output shaft | Paul Somerville | Enduro Engine 4 stroke (including EFI & Exhaust) | 0 | 11-01-2009 03:14 AM |
| Counter shaft Sprocket Seal | Rick | Enduro Engine - 2 stroke | 4 | 12-03-2007 09:00 AM |
Threaded Mode