|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2006 EC300 Jetting
Hi Guys
My first "Question" Post. I have a new to me 2006 EC 300 and need a little guidance on jetting. I have a new top end in it and has been run in, along with a good PV refurbish. The bike has loads of low down torque, but when I open her up in say 3rd just before it hits powerband it bogs or splutters a little and then clears and takes off like a scalded cat, if I change into the next gear as it happens it doesn't repeat the sputter. I am also fouling plugs after 2 or 3 rides, black and wet. So I assume this is too rich somewhere. Current setup is as follows: Carb AS1 PJ 40 MJ 175 Needle N3EH 3rd clip I bought a 38PJ but haven't tried it yet and I have raised the clip to the 2nd clip but haven't had a chance to ride it yet as I have the bike in pieces at the moment doing a refurbish and good clean up. Am I going in the right direction at the moment or what are the suggestions? Thanks Shannon |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2014 ec300 wheels on 2006 ec300 | zombiescustoms | Enduro Chassis & Body | 1 | 12-28-2015 07:44 PM |
AS1 Jetting EC300 2006 | stian | Enduro Intake/Carburetion - 2 stroke | 2 | 09-07-2015 03:01 PM |
2006 ec300 | MichaelG | Used Bikes | 2 | 08-14-2013 07:07 AM |
200 ec 2006 jetting(no expert at all) | wilkoryte | Enduro Intake/Carburetion - 2 stroke | 10 | 06-06-2007 09:46 AM |