|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
GasGas 125SM 04 Small end bearing
I've been looking everywhere for a top end bearing that will fit my piston rod and piston pin, the problem is that in the manual, it says that the bearing should be 18x22x22 but when I tried that one, it didn't fit the pin. It might have another piston kit, but I'm not sure. Does anybody know about popular piston kits for the 04 125? And if so, what type of top end bearing will fit. BTW The piston that was already in it when it broke was a w?ssner piston if that helps.
|
Tags |
125sm 04, needle bearing |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Small amount of oil in crankcase | memphis2857 | Enduro Engine - 2 stroke | 8 | 09-30-2014 10:41 PM |
GasGas small fit vs others true? Sizing changes over the years? | RonC | General Discussions & Announcements | 34 | 04-19-2013 09:27 AM |
GG ec300 - too small | Richard | General Discussions & Announcements | 15 | 02-24-2011 07:57 PM |
Small changes I would like to see. | REVERUP | General Discussions & Announcements | 92 | 01-04-2011 04:23 PM |
Small bike and ATV ban. | Ud_luz | General Discussions & Announcements | 22 | 05-04-2009 01:06 PM |