|
|
|||||||
| Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
|
Thread Tools | Display Modes |
|
#1
01-12-2019, 03:48 PM
|
|||
|
|||
Fork rebound clickers
When turning clickers all the way in to full hard will the clickers eventually physically stop? I?m asking because I am changing my springs so I turned them all the way in just to see where they were. According to the manual they are set from the factory at 14 clicks out and I never touched them. So when turning them I got to 14 and was able to go in two more but those last two were more difficult to turn, but they did turn and clicked. Just want to make sure I didn?t mess anything up by turning in too far.
Thanks 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Looking for SACHS front fork rebound adjuster GAS GAS 250 2011 | dimtsam | Enduro Suspension | 12 | 10-07-2014 01:41 AM |
| Sachs fork tube caps with rebound screw | seitz331 | "Wanted to Buy" & "Want To Trade" | 6 | 12-31-2013 01:20 PM |
| On-the-fly rebound adjustment too? Sachs fork | _Hammy | Enduro Suspension | 2 | 11-08-2013 03:55 AM |
| 48mm Marzocchi fork clickers | rbm33 | Enduro Suspension | 3 | 10-03-2013 02:19 PM |
| Fork rebound question | Jeffro820 | Enduro Suspension | 8 | 02-08-2010 08:18 PM |
Threaded Mode