|
|
|||||||
| Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
|
Thread Tools | Display Modes |
|
#11
07-24-2008, 09:19 AM
|
|||
|
|||
Thanks for the quick reply Eric,
By "that setup" I assume you mean what's in there now... I'm reasonably happy with the way the thing runs, but I really have NO basis for comparison so I wonder. The fuel consumption is one thing. Others are: - It seems to "sputter" a lot at smaller throttle openings -The "beast" within comes on with a vengeance at times too. That's why I was intrigued by Pobit's comments on the CCK needle. At 55 yrs. I don't need to loop that thing again... - It kills very easily if I get clumsy about braking into corners.
__________________
Ross '05 MC 250 '91 Husky 610wxe '04 Duc M800 R.I.P '06 Duc S2r 1000 R.I.P '07 Duc S2r 1000 still rubber side down... ---------------------------------------------------------- May be so... May be not so... My Website 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| VALVE adjustment | west aussie gas 450 | Enduro Engine 4 stroke (including EFI & Exhaust) | 22 | 03-25-2013 02:50 PM |
| Help! Flywheel weight doesn't fit with 2k3 on 2003 EC250? | SideshowBob | Enduro Engine - 2 stroke | 12 | 04-28-2010 11:02 PM |
| idle speed adjustment | Qui-gon | Enduro Engine 4 stroke (including EFI & Exhaust) | 5 | 04-07-2008 06:07 PM |
| It doesn't fit.... | stay_upright | General Discussions & Announcements | 7 | 03-04-2008 12:55 PM |
Threaded Mode