|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Power valve governor assembly help!
So I pulled the side cover off my 2012 EC 300 Race to attempt to take the slack out of the power valve actuator (which there was lots of slack in). While I was in there I decided to open up the governor to see if all 6 balls were in there and not worn weird. Now I can?t get the balls to line up to reassemble. It would be easier if I could pull the shaft right out and assemble it upside down (I?m guessing), but I can?t pull the shaft out! I keep pulling on it and it just won?t pop out. Doesn?t look like anything is in the way. What am I missing? Please help. I gatta get this bike back together ASAP. Thanx
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ec 250 power valve governor what year gg did change from 4 ball to 6 ball | rvktm | Enduro Engine - 2 stroke | 3 | 04-16-2020 05:49 PM |
Exhaust Valve Governor Assembly | mcnut | Parts | 3 | 11-13-2015 10:36 AM |
Yet another Power Valve/Govenor Assembly question | mp5 | Enduro Engine - 2 stroke | 15 | 07-24-2013 05:32 PM |
Power Valve Re-Assembly | rootsnrocks | Enduro Engine - 2 stroke | 5 | 01-13-2013 09:39 PM |
Power Valve Assembly Help Needed | bondo | Enduro Engine - 2 stroke | 4 | 12-29-2010 09:34 AM |