Pressure test clutch bubbles!

[CrankyBrit]

Originally Posted by Anders

...there should never be a need for drive the flywheel onto its taper with anything but your own fingers. It is a loose fit until it is onto the taper.

I figured there was no good reason the thread should have been smashed.

Here's a picture of the smashed thread...

...you can see the outer two rings of thread are hardly visible where they've been flattened.

I couldn't make a puller for the outside work, so resorted to the one that I purchased. I had to grind out the smashed bits like so...

...I don't think it'll effect the balance.