|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
A peek inside my '05 DE250
While it was up on the stand (tire changes) I decided to take off the pipe (to straighten it), and take some pics of the piston and stuff in preparation for my June-ish top-end inspection and R & R.
A series of photos starting with the exhaust area. The photo's aren't showing so just click on the links... Next is a pic of the side of the piston (no rings showing)... Next is the top of the piston with a little ring action... And finally a glance at the back of the cylinder wall. Notice the cross-hatching direct from the Spanish factory... |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fuel lines - Inside or outside of frame? | lukemillar | Enduro Engine 4 stroke (including EFI & Exhaust) | 6 | 09-09-2009 04:57 PM |
Triple Clamps clearance- Does this looks right?! PIX INSIDE | alexpp | General Discussions & Announcements | 8 | 04-15-2009 09:14 PM |
2010 Race model sneak peek | Skidad | General Discussions & Announcements | 6 | 02-28-2009 04:22 AM |
Double pager in Inside Motorcycles | SpeedyManiac | Pictures & Videos | 10 | 12-29-2008 11:17 AM |