|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
I use the screw driver method. Before my backpack with a sweet selection of tools got stolen I used a chain press. Regarding installation of the masterlink, I recently saw pictures of the cases on a WR that had a masterlink failure and they were ugly. A simple way to prevent such a catastrophe is to install the master link such that the clip is on the inside of the cahin. If it fails, it would come out away from the cases not grind/cut into them.
Paul B 02 se 300 02 WRX |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how do you remove the kickstart | noobi | Enduro Chassis & Body | 13 | 09-22-2011 03:31 PM |
is there a master link? | mountain thumper | Enduro Chassis & Body | 4 | 07-09-2008 05:36 AM |
How best to remove carbon from PV components? | d2w | Enduro Engine - 2 stroke | 9 | 02-21-2008 09:03 PM |
Periodically remove and re-fit all bolts? | stay_upright | General Discussions & Announcements | 2 | 01-14-2008 07:56 PM |
Another Master-link question | FFRDave | Enduro Chassis & Body | 5 | 10-21-2006 07:48 AM |