![]() |
|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
HELP,
I have her stripped down, bent part of shift shaft cut off smooth with a Dremel. The shaft will not budge, I have pounded the hell out of the cut off side and it won't move. Any suggestions, I sure don't want to take it to the shop all stuck like it is. Any help appreciated. Trailrider Jim 2001 XC300 |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
shift problems.. | stainlesscycle | Enduro Engine - 2 stroke | 1 | 05-11-2010 06:25 PM |
Gear shift shaft question (again) | Trailrider | Enduro Engine - 2 stroke | 7 | 04-06-2010 09:54 AM |
Transnission shift shaft. | Trailrider | Enduro Engine - 2 stroke | 15 | 02-28-2010 05:10 PM |
Shift Lever | PEB | Enduro Chassis & Body | 6 | 09-29-2009 05:45 PM |
cam shaft problems on a fse400 2002 | teapaz | Enduro Engine 4 stroke (including EFI & Exhaust) | 7 | 02-03-2009 06:13 PM |