|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2010 Sachs EC300 Fork Problem
One of the rebound clickers was stuck and had no movement after being serviced.
I proceeded to take the top cap off, turns out the stuck clicker was caused by top cap being tightened to much. The problem I now have is that the fork with the previously stuck clicker now seams to have about 30 clicks of range from full out, where the other fork which had no previous problems to my knowledge only has about 18 clicks in from full out. The setting of both forks when I got the bike wer 2 click in from full out. Any ideas what may be the cause of the problem Im now faced with?? Thanks for any advice
__________________
2010 EC 300 and counting |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2010 Sachs Fork Seals | Bradz | Enduro Suspension | 7 | 01-04-2011 12:06 PM |
SACHS fork thread | jra_enduro | Enduro Suspension | 2 | 11-05-2010 04:58 PM |
2010 sachs forks | bowtech | Enduro Product Announcements | 13 | 09-09-2010 07:50 AM |
2010 Sachs fork factory compression stack specs(ec300) | bergerhag | Enduro Suspension | 9 | 07-01-2010 11:18 PM |
sachs fork | moto9 | General Discussions & Announcements | 0 | 09-28-2009 07:51 PM |