|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#9
|
|||
|
|||
I tried the n3ch 3rd clip, 40 pilot and 175 main. Airscrew about 1.5 turns out.
500ft asl temps around 50degrees F. The bike starts good and runs crisp from the first crack of the throttle. It has quite a bit more snap than with the n1ef needle. It seems to rev out better as well. I may try a 178 main and see if that makes any difference as well. It felt like it may be able to use a little more fuel up top. When you hit a long straight at wot then back off it would make a little noise, or surging. Very little but enough to make me think it could use a little more fuel. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2010 250 EC Jetting. | enduro1 | Enduro Intake/Carburetion - 2 stroke | 13 | 08-19-2010 05:56 PM |
2010 Sachs fork factory compression stack specs(ec300) | bergerhag | Enduro Suspension | 9 | 07-01-2010 11:18 PM |
2010 EC250 Jetting | WTEC | Enduro Intake/Carburetion - 2 stroke | 1 | 03-26-2010 09:41 AM |
jetting for new 300 racing 2010 | fabulous furry | Enduro Intake/Carburetion - 2 stroke | 9 | 08-11-2009 09:28 AM |
04 EC300 jetting? | DWreck | Enduro Intake/Carburetion - 2 stroke | 13 | 11-26-2006 08:12 PM |