|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#11
08-16-2006, 09:38 AM
|
|||
|
|||
You guided me to the correct direction! I just adjusted the clutch freeplay. It was too much. More than 1 cm! I followed the manual for 2-3mm. I am so angry to myself! I am so picky about many things and just did all the work myself with your help and I just don't check some basic small things! I hope tomorrow everything shifts smoothly! It should.
(I changed the 4 bearings (1 was broken and another was stucking), the 2 o-rings and the quite grooved spacer. Everything caused from me (the freeplay..) and a loose flatland skidplate which was causing the shift lever to stuck in every downshift (many false neutrals..) during a local race here in Finland.) Thank you again so much!! Leon 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| EC250 Questions from a new member | Stef | Enduro Engine - 2 stroke | 6 | 03-04-2010 08:46 PM |
| Used EC250 Questions | OhioPT | General Discussions & Announcements | 7 | 04-30-2009 11:24 AM |
| EC250 to 300 Questions | dave948 | Enduro Engine - 2 stroke | 4 | 01-15-2009 06:12 PM |
| Dual sported 06' EC250 questions......... | Harv | General Discussions & Announcements | 5 | 11-05-2008 04:43 AM |
| Milky gearbox oil | juzzasmith | Enduro Engine - 2 stroke | 10 | 03-12-2007 05:40 PM |
Threaded Mode