Rieju & GasGas Legacy Riders Club Forum  

Go Back   Rieju & GasGas Legacy Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 08-18-2006, 10:03 PM
cladoo's Avatar
cladoo cladoo is offline
Site Sponsor
 
Join Date: Aug 2006
Location: Okotoks, Alberta, Canada
Posts: 557
Default

jeffd: 1. I don't think its lean a little rich if anything.
2. I have an '06 300EC
3. The other 5 bikes were KTMs, a 250XCW, two 300XCW's and two 450EXC's.
4.Fuel mileage is better now with a Clarke tank, at least it will go farther now!
5. I am running Flatland guards. But so did everyone else.
6. I checked the level before the ride and it was fine, a little low if anything. The bike has the expansion tank.
As far as weight goes I wasn't the heaviest guy there. I weigh about 215lbs.
Claude
Reply With Quote
 




Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Engine Coolant c-152 Enduro Engine - 2 stroke 4 07-02-2010 04:19 PM
Coolant and 1.8 bar cap? wence Enduro Engine - 2 stroke 8 03-11-2010 09:31 PM
losing coolant Gassey fan Enduro Engine - 2 stroke 3 02-24-2010 12:18 AM
Puking coolant Metalefty Enduro Engine 4 stroke (including EFI & Exhaust) 17 11-28-2009 09:26 AM
coolant over flow west aussie gas 450 Enduro Engine 4 stroke (including EFI & Exhaust) 7 02-10-2008 04:24 PM




All times are GMT -5. The time now is 05:01 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org