|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
12-15-2011, 11:45 PM
|
|||
|
|||
Best setup for ec300 2011 in hard enduro
Pretty new here and at GG family, just picks up ec 300 2011 riding in very tight woods, rocks...
After reading a lot of post, I see that the most common tip is to use higher gear and lug it... But in some place putting the 3rd or even the 2nd gear isnt fit to the specific area and the motor is run away without rotating the throttle. What is the best setup to smooth the power, and create linear motor? Jetting? reed spacer? Power valve? Currently running with everything stock, sea level, 20 degree Celsius Thanks. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Brentwood HARD Enduro- Day 2 | roughside | Pictures & Videos | 3 | 10-10-2011 02:54 PM |
| Brentwood HARD Enduro- day 1 | roughside | Pictures & Videos | 4 | 10-02-2011 09:51 AM |
| Brentwood Hard Enduro-- Special Test # 1 | Looki | Pictures & Videos | 11 | 09-03-2011 10:41 PM |
| 08 EC300 setup MX & Enduro | AdrenalineJunky | Enduro Suspension | 4 | 06-03-2010 09:41 AM |
| The best light setup for an 07 Ec300??? | wence | Enduro Electrical & Wiring | 9 | 03-25-2009 08:42 AM |
Threaded Mode