|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
Not content with a mere lay down cylinder like the Ossa, GG pulled out the stops and did a completely upside down motor, with fuel tank on the bottom for low CG. Thats the reason for the delay, you 300 guys missed out. Either that or Android phone picture anamoly, you choose.
Yeah, 2K-2 and older PWK AS I carb to my surprise. I'm fine with that, in fact I prefer it. I can toss my JD jetting specs in and be there with no drama. I haven't taken it off and measured it yet but I hope its a 38mm. I was going to swap ignitons anyway as well. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Anybody know these guys? | dinobody | General Discussions & Announcements | 1 | 03-12-2012 08:06 AM |
Guys i need your help ! | moto9 | General Discussions & Announcements | 17 | 02-11-2012 10:50 PM |
drive plate replacement, sharp edge in or out? | dank | Enduro Engine - 2 stroke | 7 | 06-25-2010 07:11 AM |
ok guys i need help again....... | dank | Enduro Chassis & Body | 16 | 05-08-2010 05:55 PM |
Don't hate me, I need you guys | thelonius | General Discussions & Announcements | 6 | 11-18-2007 01:53 PM |