|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
2006 EC 200 tickover
Finished rebuilding my new (to me) ec 200 engine. The two main concerns are:
1/ It will fire up with the first half hearted kick from cold with no choke. 2/ It cannot be set to tickover on the tickover screw. (Although it will tickover if I remove the spring from the screw and wind it in so that the head of the screw is 5mm from seat) The engine sounds ok, although I am reluctant to run it in without being confident about the jetting. Can anyone identify errors or suggest changes to the following set- up ? main jet 175 slow jet 45 slide 6 needle N8HW 2nd clip airscrew 1.5 out carb body to float measurement 16mm squish 1.2 mm boyeson reeds new wossner piston and rings new B8EGV plug clean and oiled air filter fmf gnarly and repacked standard silencer
__________________
'00 Montesa Cota 315R '13 Husaberg TE 300 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Low down / tickover issue HELP | stevehipkiss | Enduro Intake/Carburetion - 2 stroke | 9 | 02-14-2011 09:03 AM |
tickover | jetfish | Enduro Engine - 2 stroke | 3 | 01-18-2010 10:53 AM |
Rough erratic tickover | mcludd | Enduro Engine 4 stroke (including EFI & Exhaust) | 7 | 05-26-2009 12:01 PM |