|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#12
12-02-2015, 03:00 AM
|
||||
|
||||
Righto, soaked in WD40 for a day or so, then ran over it with a brass wire brush disc which runs on the cordless drill. Then used a automotive metal polish................and it came up great.
Wish I had done a before and after pic now. 
__________________
A Kiwi Gasser on a EC200 2010. 
|
|
#13
12-02-2015, 01:19 PM
|
|||
|
|||
|
Buy the stainless gas gas pipe, it fits all years with a different mount, and is dirt cheap!
__________________
2006 EC300 Enduro - Ignitech CDI - 38/NECW#2/165 FMF gnarly, FMF shorty, .50 front 5.7 rear 2016 RM-Z450
|
|
#14
12-06-2015, 08:03 PM
|
|||
|
|||
|
stainless gasgas pipe?? never heard of it, but certainly would like to buy one. Anyone have a part # by chance? my local dealer for sure has never heard of it, and sure as hell would have a million excuses as to why they could not get me one. They probably have not even heard that the brand almost went tits up recently!
|
|
#15
12-07-2015, 03:20 AM
|
|||
|
|||
|
Just a thought I had using a cold galvanized spray might be of benefit. The color should be a fairly close match and stop the rust, not sure how heat resistant that they are though. Might suffice for the spots that seem to show up near the header.
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Clean 01 EC200 | memphis2857 | Used Bikes | 1 | 03-09-2015 11:48 AM |
| GG need to polish up on some after thought | Fakesy | General Discussions & Announcements | 15 | 04-14-2013 04:40 PM |
| High pitch Squealing from exhaust and exhaust flange????? | Scar13 | Enduro Engine - 2 stroke | 5 | 02-11-2012 11:32 AM |
| Mothers Metal Polish | Boomhauer | Enduro Product Reviews | 3 | 06-23-2007 07:02 AM |
Linear Mode
