|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Clutch master cylinder
Looking for options to replace the stock AJP clutch master cylinder assembly. Any suggestions for a direct bolt up? thanks in advance.
|
#2
|
||||
|
||||
Motocenter AZ has the BrakeTec (who, somehow, acquired the assets/IP of AJP) rebuild kits for the AJP master cylinder. My MC is 20 years old w/o a rebuild, but i have a kit just in case. Much cheaper alternative FWIW.
|
#3
|
||||
|
||||
You need to pay attention to and match the fluid type unless you want to put the corresponding seals into the slave cylinder too. Magura and Brembo have other options.
|
#4
|
||||
|
||||
I would suggest a Magura, as they were used on Gasgas in some models. If you get one of the same type that was used as OEM, it should fit right in.
__________________
Anders "So you know, that you're over the hill when your mind makes a promise that your body can't fill" (Little Feat: Old Folks Boogie) 2015 EC200 Racing: TE bars, Rekluse Core Exp 3.0, 38mm Lectron & Ohlins S3 steering damper 2006 EC200: 2011 plastics, Rekluse Z-Start, revalved KYB forks & Scotts steering damper 1998 Bimota Supermono 1986 Duc Mille S2 1975 Guzzi sidecar hack 1961 Morini Corsaro 125 etc |
#5
|
|||
|
|||
Thank you for the replies. I purchased a rebuild kit off E-bay awhile back and it did not function. I believe it was mislabeled for the fluid I required. The seals failed in a short amount of time. Fortunately I bought a used assembly and it has been working pretty well. Was hoping to find a newer more readily available assembly. The OEM doesn't appear to protect very well for mud and debris.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wanted Clutch Master Cylinder DOT-4 | Zman | "Wanted to Buy" & "Want To Trade" | 1 | 02-04-2021 01:34 PM |
How to Bleed KTM-HQV Clutch Master Cylinder | Moto7man | Pictures & Videos | 0 | 08-19-2019 12:57 PM |
Need a clutch master cylinder rebuild kit | Ashman | Enduro Chassis & Body | 1 | 06-28-2017 05:05 AM |
Clutch Master Cylinder DOT 4 | Zman | "Wanted to Buy" & "Want To Trade" | 0 | 03-11-2017 09:09 PM |
Clutch Master Cylinder | Cory C | Enduro Chassis & Body | 2 | 05-03-2016 03:24 PM |