![]() |
#1041
|
|||
|
|||
![]()
Being from Austria the brand with the 3 letters I don't dare to speak out loud here is a more or less natural choice
![]() ![]() Michael |
#1042
|
||||
|
||||
![]()
Thanks Michael.
I'll give it a good going over when I have the shock out for its next service. Todays quick ride was feeling pretty nice though. I also noticed my pipe o-rings have blown out and I'm getting a dribble of spooge from the exhuast spigot. Not sure if this could be contributing to some of the roughness off idle. |
#1043
|
||||
|
||||
![]()
I had chance to have a good play yesterday , I started with float at 18mm and 58 clicks out on the needle , this was way too lean and ended up with the hanging idle , kept adjusting it until I was happy and you could literally chug the bike up a steep hill without stalling her , I thought I was at around 40 clicks but it turned out to be 29 clicks out and needle to top of slide length of 97.58mm .
Not that I'm great at wheelies but you could litterally roll the throttle on from nothing in the first three gears and lift the front wheel . it does seem to me that with this needle the top is a bit flat compared to before though One thing to note is that I fitted a Leo vince tail pipe before testing this needle , but I can't see that having much influence on the settings . I should be putting a vid on later of my final setup , ignore the 40 clicks out comment as it was 29 and I'd lost count . http://m.youtube.com/watch?v=IM_NBI6-jaY Last edited by Diggs345; 07-24-2013 at 01:59 PM. |
#1044
|
|||
|
|||
![]()
Sounds really good and the pull off idle...sweet! I wonder if the flat feeling on top is really flat or just feels that way because it's so smooth. My Husky 165 with the SC feels smooth on top but not flat and backed up when I did some roll on races with a friend as his YZ 250F. I walked away from him very quickly every time. He "thought" because my bike is so smooth it wasn't very fast now he knows smooth can be fast. Anyway looks like you have your bike dialed in pretty good.
|
#1045
|
||||
|
||||
![]()
I wish mine ran that well..
I put a load more kms on mine over my days off. Didn't change more than a click the whole time. Started rich, then went leaner later in the ride.. but by the end of the ride it was feeling rich again. I'm still getting inconsistant results with it. Managed to pinch flat the rear, and the vibes broke the pipe mount tab out of the frame rail again. I need to isolate the pipe a bit better. Have previously had it all but hard mounted to stop the pipe rattling on the header. Next ride will include new pipe o-rings, springs, and a new isolator for the lower mount. Not sure how I'll do this yet.. hopefully this will see an improvement. Touch wood. |
#1046
|
||||
|
||||
![]()
My header o rings want swapping out too , maybee that will account for the flat feeling on top or maybe you are right John .
Jake , mine was inconsistent until I put some sealer on the gasget surfaces and raised the tickover a little . Ill order some more o rings and give it another go . |
#1047
|
|||
|
|||
![]()
Folks I think we have a winner here.
Cast 38mm SC sitting on my desk full of fuel. No worries about spilling fuel with a fully self contained SC. Carb can be disassembled with one allen wrench. Also some pics of internal check valves and new hex clicker. Tomorrow we will post some video of how sick this carburetor really is. Super low idle capability, unbelievably smooth, awesome roll on, and of course it will run on its side no flooding and starts with one kick. I've been around these carbs for a while but I am really excited about this one! ![]() ![]() ![]() ![]() |
#1048
|
|||
|
|||
![]()
Box 'em up and ship them out!
__________________
2011 EC300 2013 TXT300 Factory Replica 2014 Polaris Assault 2004 Snowhawk 600H.O. |
#1049
|
||||
|
||||
![]()
Corey,
Has there been any updating to the MR from the billet units to the cast? If so, could those of us with a billet benefit from upgrading MR's?
__________________
Newest Spanish Girlfriend: 2011 300 Six Days My Daughter is a U.S. Marine |
#1050
|
|||
|
|||
![]() Quote:
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
APT SmartCarb | siaknijustin | Enduro Product Announcements | 19 | 10-02-2012 08:12 AM |